Document Type - Research

Motor Design: Overview

Motor Design: Seat Motor

Motor Design: Window Lift Motor

Motor Design: Fuel Pump Motor

Motor Design: HVAC Blower Motor

Motor Design: Engine Cooling Fan Motor

Motor Design: Wiper Motor

Motor Design: Power Tool Motor

MQI Virtual Motor: Fuel Pump

Advanced AA Technology

Magnetization Guide

Bonded Neo for Energy Efficient Automotive Accessory Motors

Material Difference (Article in "appliance DESIGN")

High performance nanostructured Nd-Fe-B fine powder

Journal of Applied Phyiscs 107, 09A730 (2010)
Research and development paper on High performance nanostructured Nd-Fe-B fine powder prepared by melt spinning and jet milling by Dr. Zhongmin Chen,Senior Scientist, Mr. David J. Miller,Director of Research & Development and Dr. Jim Herchenroeder, Vice President.

Copyright (2010) American Institute of Physics. This article may be downloaded for personal use only. Any other use requires prior permission of the author and the American Institute of Physics. The following article appeared in (Journal of Applied Physics (Vol.107, Issue 9) and may be found at http://link.aip.org/link/?JAP/107/09A730

Seat Motor: Benchmark Anisotropic HDDR vs MQP

Seat Motor: Benchmark Anisotropic HDDR vs MQA

Automotive Accessory Motors

Ceiling Fan Motor Design Analysis

Optimization of Melt Spun RE-Fe-B Powder Composition for Fully Dense, High Energy Magnets

High performance bonded neo magnets using high density compaction

Journal of Applied Phyiscs 109, 07A743 (2011)
Research and development paper on High performance bonded neo magnets using high density compaction by J. Herchenroeder, D. Miller, N. K. Sheth, M. C. Foo, and K. Nagarathnam

Copyright (2011) American Institute of Physics. This article may be downloaded for personal use only. Any other use requires prior permission of the author and the American Institute of Physics. The following article appeared in (Journal of Applied Physics (Vol.109, Issue 7)) and may be found at http://link.aip.org/link/?JAP/109/07A743

Optimization of melt spun RE-Fe-B powder composition for fully dense, high energy magnets

Journal of Applied Phyiscs 109, 07A742 (2011)
Research and development paper on Optimization of melt spun RE-Fe-B powder composition for fully dense, high energy magnets by D. N. Brown, Y. K. Lim, R. A. Remoroza, and D. J. Miller

Copyright (2011) American Institute of Physics. This article may be downloaded for personal use only. Any other use requires prior permission of the author and the American Institute of Physics. The following article appeared in (Journal of Applied Physics (Vol.109, Issue 7)) and may be found at http://link.aip.org/link/?JAP/109/07A742

Microstructure and properties of Ni-Mn-Ga alloys produced by rapid solidification and pulsed electric current sintering

Bonded neodymium magnets

Permanent Magnet Synchronous Motor Drive Using Hybrid PI Speed

© 2011 IEEE. Reprinted, with permission, from Amit Vilas Sant, K. R. Rajagopal , and Nimit K. Sheth, Permanent Magnet Synchronous Motor Drive Using Hybrid PI Speed Controller With Inherent and Noninherent Switching Functions, IEEE TRANSACTIONS ON MAGNETICS, VOL. 47, NO. 10, OCTOBER 2011]

This material is posted here with permission of the IEEE. Such permission of the IEEE does not in any way imply IEEE endorsement of any of Magnequench's products or services. Internal or personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution must be obtained from the IEEE by writing to pubs-permissions@ieee.org. By choosing to view this document, you agree to all provisions of the copyright laws protecting it.

Why Dysprosium is used in rare earth magnets

Sintered Neo Replacement